Ashdown ABM EVO III Operations Instructions download pdf (Page 7)

Rear Panel Facilities

LINE INPUT - The rear panel has a Line Input

socket for connection of other signal sources

into the system. This can be used for

plugging a CD, Tape or MP3 player into the

amplifier for practising, rehearsing or for

connection of a second pre-amp into the

system.

EFFECTS SEND / RETURN - A serial effects

loop is provided at a level of 0dB.

The EFFECTS SEND socket can also be used as

a Line Out socket if required as the signal

path through the preamp is only broken

when a jack plug is inserted into the EFFECTS

RETURN socket.

The EFFECTS SEND is situated after the EQ,

the Valve section the Compression and the

Sub Bass Processor.

4-WAY FOOTSWITCH SOCKET - For the 4

way footswitch to operate it is essential that

the corresponding front panel push buttons

be in the OUT position.

This is a mono jack socket for connection of

the optional Ashdown 4 way footswitch only

(available from your Ashdown dealer, or

online at www.ashdownmusic.com/shop).

Always connect this prior to turning on the

power to the amplifier as the footswitch

derives its power from the amplifier and

sends a serial data stream to the amplifier in

order to operate the various functions.

Each of the 4 facilities available for selection

is indicated by an LED that will light when

that facility is selected from the footswitch.

CROSSOVER AND OUTPUTS (Rack Preamp

only) - The BASS MAGNIFIER RACK PRE-AMP

has a built in high precision CROSSOVER with

separate jack socket outputs for the HIGH

PASS and LOW PASS signals.

Crossover frequency is adjustable from 35 to

160Hz with a level control for the LOW PASS

output to adjust the balance between LOW

and HIGH outputs signals.

There is also a FULL RANGE jack line output

provided.

This section is provided with switched output

levels for simplified connection to power

amplifiers that require either a 0dB or +4dB

signal level. This switches the levels of all

three outputs.

SPEAKER OUTPUT (except Rack Preamp) -

The Speaker Output sockets are also situated

on the rear panel of the unit.

o

I

EVOIII 500

EVOIII 900

EVOIII Rackmount Preamp

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments